So my opinion is: with AsProgrammer you have better Chip Detection and can only programm the chip, if the software knows which chip is connected.Īt least: Its good for environment to repair things like that, before it comes to trash. I say this, because CH341a.exe dont detected my chip, but i was able to erase it, if I wanted to write it = i had a ERROR. I read that on the linux the flash software is pretty good. ** You can use another software of course. **ATTENTION: IF YOU FLASH THE WRONG CHIP (WITHOUT SAVING A DUMP): YOU CAN BRICK YOUR MAINBOARD AND NEED THEN REPLACEMENT** So take care and do a backup before erase, blank and programming! **DO THIS IF YOUR WARRANTY TIME IS GONE AND YOU HAVE NO OTHER SOLUTION** Otherwise try the steps on the linked youtube video for the connection between the programmer and chip connection. If everything is good connected, at the point where you click on "Detect (green ?)" at AsProgrammer, a list should pop up with 2 choices (Chips from GD25B family). Also in Windows Defender Security Center. Click Virus & threat protection settings. On Studio Edition 2019 installed chip is GD25B127D ( ) Also do the following: Open Windows Defender Security Center. Pin 1 on the chip is where I made the red dot in the attached picture “pin 1 bios chip”. Pin 1 on the clip is where the red cable is. "Connect pin 1 of the clip to pin 1 of the bios chip. Connect to a another laptop with the chip (like this):
#Uniextract update#
With "UniExtract" extract the Razer Update and find the 16 MB Bios *.bin File (in my case it was named Charlotte4_0105.bin)ĥ. Download "UniExtract" from Github and the Razer Updateģ. Buy CH341a Programmer with soi8 connectorĢ.